Dodge ram truck 3500 1996 Service Manual page 498

8L - 8 LAMPS
B R
L A M P B U L B S E R V I C E
INDEX
page
REMOVAL AND INSTALLATION
CARGO LAMP BULB 9
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB 9
DOME LAMP BULB 10
FOG LAMP 8
FRONT SIDE MARKER LAMP BULB 9
HEADLAMP 8
LICENSE PLATE LAMP BULB 10
OVERHEAD CONSOLE READING LAMP BULB . 10
page
PARK AND TURN SIGNAL LAMP 8
REAR IDENTIFICATION (ID) LAMP BULBS 10
ROOF CLEARANCE LAMP BULB 9
SIDE IDENTIFICATION (ID) LAMP BULBS 9
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMP BULB—CAB CHASSIS 9
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMP BULB—PICKUP 9
UNDERHOOD LAMP BULB 10
R E M O V A L A N D I N S T A L L A T I O N
HEADLAMP
On driver side and on vehicles with dual batteries,
the headlamp assembly must be removed to service
the headlamp bulb.
R E M O V A L
(1) Release hood latch and open hood.
(2) To remove headlamp assembly on drivers side
or passenger side when equipped with dual batteries,
refer to Headlamp Removal paragraph of Exterior
Lamps section.
(3) Disengage wire connector from headlamp bulb.
(4) Remove retaining ring holding bulb to head­
lamp (Fig. 1).
(5) Pull bulb from headlamp.
INSTALLATION
CAUTION: Do not touch the bulb glass with fin­
gers or other oily surfaces. Reduced bulb life will
result.
(1) Position bulb in headlamp.
(2) Install retaining ring holding bulb to headlamp
(Fig. 1).
(3) Connect wire connector to headlamp bulb.
F 0 i LAMP
BULB
SOCKET
REMOVAL
(1) Disengage fog lamp harness connector.
(2) Rotate bulb assembly counterclockwise
pull from lamp to separate (Fig. 2).
and
BULB
RETAINING
RING
ELECTRICAL
CONNECTOR.
LENS/
REFLECTOR
UNLOCK
918L-34
Fig. 1 Headlamp Bulb Removal
INSTALLATION
CAUTION: Do not touch the bulb glass with fin­
gers or other oily surfaces. Reduced bulb life will
result.
(1) Position bulb assembly in lamp and rotate
clockwise.
(2) Connect fog lamp harness connector.
PARI AND TURN SIGNAL LAWIP
REMOVAL
(1) Remove park and turn signal lamp.
(2) Rotate bulb socket 1/4 turn counterclockwise
and pull turn signal lamp socket from back of lamp.
(3) Pull park and turn signal lamp bulb from
socket.
INSTALLATION
(1) Install park and turn signal lamp bulb i n
socket.
(2) Install park and turn signal lamp socket into
back of lamp.
(3) Install park/turn signal lamp.