Dodge ram truck 3500 1996 Service Manual page 412

8D - 30 IGNITION SYSTEM
HEH@WAL AHP INSTALLATION {Continued)
LOCATING PIN HOLE
K LOCK S L I D E R / X
^ L I N K A G E ^ - ^ ^
Fig. 74 ignition Switch Mounting Pad
(3) Place ignition switch against lock housing
opening on steering column. Ensure that ignition
switch park lock dowel pin enters slot in park lock
slider linkage in steering column.
(4) Install retaining bracket and ignition switch
mounting screws. Tighten screws to 3±.5 N-m (26±4
in. lbs.) torque.
(5) Install ignition lock cylinder:
(6) With lock cylinder and Ignition switch in Lock
position, insert lock cylinder into ignition switch
until It bottoms.
(7) Insert ignition key into lock cylinder. While
gently pushing lock cylinder In toward ignition
switch, rotate ignition key to end of travel.
(8) Install retaining screw into bracket and lock
cylinder. Tighten screw to 3±.5 N-m (26±4 in. lbs.)
torque.
(9) Install steering column covers. Tighten screws
to 2 N-m (17 in. lbs.) torque.
(10) I f vehicle is equipped with a tilt steering col­
umn, install tilt lever.
(11) Connect negative cable to battery.
(12) Check for proper operation of halo light, shift
lock (if applicable), and column lock. Also check for
proper operation of ignition switch accessory, lock,
off, run, and start positions.
COLUMN SHIFT INTERLOCK
The column shift interlock is used to lock the
transmission shifter in the Park position when the
key is in the Off position. The interlock device is
located within the steering column assembly and is
not servicable. I f repair is necessary, the steering col­
umn assembly must be replaced. Refer to Group 19,
Steering for procedures.
S P E C I F I C A T I O N S
VEC1 LABEL SPECIFICATIONS
I f anything differs between the specifications found
on the Vehicle Emission Control Information (VECI)
label and the following specifications, use specifica­
tions on VECI label. The VECI label is located in the
engine compartment.
IGNITION TIMING
Ignition timing is not adjustable on any engine.
Refer to Ignition Timing in the Diagnostics/Service
Procedures section of this group for more informa­
tion.
ENGINE FIRING ORDER—3.9L V-6 ENGINE
FRONT
OF
ENGINE
CLOCKWISE ROTATION
1-6-5-4-3-2
J9314-80
ENGINE FIRING ORDER—5.2L/5.9L V-8 ENGINES
a
FRONT
OF
E N G I N E
CLOCKWISE ROTATION
1-8-4-3-6-5-7-2
J9314-79