Clutch Housing Replacement-Nv4500 - Dodge ram truck 3500 1996 Service Manual

6 - 18 CLUTCH mm
R E M O V A L AW© I N S T A L L A T I O N (Continued)
APPLY LIGHT COAT O F
HI-TEMP GREASE TO THESE
SURFACES BEFORE INSTALLATION • J9106-15
Fig. 29 input Shaft Lubrication Points—Typical
pivot ball and release bearing on fork are properly
installed and (Fig. 30).
FORK
J9406-18
Fig, 30 Release Fork And Bearing Spring Clip
Position
(12) Install clutch housing (Fig. 31) and (Fig. 32).
Be sure housing is properly seated on alignment
dowels before tightening housing bolts.
(13) Install transmission.
(14) Check fluid level in clutch master cylinder.
CLUTCH HOUSING REPLACEMENT—NV4500
Only the NV4500 clutch housing is serviced sepa­
rately. The NV3500 clutch housing is part of the
transmission front case and is therefore serviced only
as part of the case assembly.
(1) Raise vehicle and remove transmission and
transfer case i f equipped.
(2) Remove clutch housing bolts and remove hous­
ing from engine (Fig. 33) and (Fig. 34).
(3) Clean housing mounting surface of engine
block with wax and grease remover.
ENGINE BLOCK CLUTCH DISC A N D COVER
J9O06-32
Fig. 31 Clutch Housing Installation—NV4500
Fig. 32 Clutch Housing/Transmission Installation—
Diesel Engine
(4) Verify that clutch housing alignment dowels
are in good condition and properly seated.