Dodge ram truck 3500 1996 Service Manual page 78

_ . ..1L.1MHML
ANU DRIVELINE ^ ^ • ^ • ^ B R
D I S A S S E M B L Y A N D A S S E M B L Y { C o n t i n u e d )
• (2) Place a bearing assembly in a tube yoke hole
and over a trunnion. Keep the needle bearings
upright in the bearing assembly (Fig. 27). A needle
roller lying at the bottom will prevent proper assem­
bly. Be sure to remove any lube fittings that may
interfere with removal.
(5) Fit the center yoke on the remaining two trun-
Fig. 27 Install Bearing Assembly
n i o n s a n d p r e s s b e a r i n g a s s e m b l i e s i n p l a c e , b o t h
(3) Press the bearing assembly in place and install sides (Fig. 30). Install a snap ring,
a snap ring (Fig. 28).
Fig. 28 Press In Bearing Assembly
(4) Flip the tube yoke and bearing assembly instal­
lation on the opposite trunnion. Install a snap ring
(Fig. 29).