Mic-Glove Box-Map Lamp Output Circuit Short Or Open - Dodge Ram 2004 Service Manual

Symptom:

MIC-GLOVE BOX-MAP LAMP OUTPUT CIRCUIT SHORT OR OPEN

INTERMITTENT CONDITION
GLOVEBOX-MAP LAMP OUTPUT CIRCUIT SHORT TO GROUND
INSTRUMENT CLUSTER
TEST
1 Turn the ignition on.
With the DRBIII , clear all MIC DTC's.
Turn the Glove Box Lamps on.
With the DRBIII , read the DTC information.
Does the DRBIII read: Glove box/Map Lamp Output Circuit Short/Open?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the Glovebox Lamp Switch Harness connector.
Disconnect the Instrument Cluster C1 connector.
Measure the resistance of the Glovebox Lamp Output circuit to ground.
Is the resistance below 5.0 ohms?
Yes → Repair the Glovebox-Map Lamp Output circuit..
→ Replace the Instrument Cluster.
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
INTERIOR LIGHTING
459
APPLICABILITY
All
All