Dodge ram truck 3500 1996 Service Manual page 205

B R BRAKES 5 - 21
REMOVAL AND INSTALLATION (Continued)
Fig. 32 Booster Mounting
INSTALLATION
NOTE: If new booster is being installed, check
code letters to verify that correct booster is being
installed.
(1) Position booster on engine compartment dash
panel.
(2) Install and tighten booster mounting stud nuts
to 23-34 N-m (200-300 in. lbs.).'
(3) Connect booster push rod to brake pedal.
(4) Install knee bolster.
(5) Connect vacuum hose to booster check valve.
(6) Install master cylinder and valves on booster
as assembly and tighten mounting nuts to 23-34 N-m
(200-300 in. lbs.).
(7) Connect front/rear brake lines to combination
valve and RWAL valve. Tighten brake line fittings to
16-23 N-m (140-200 in. lbs.).
(8) Connect harness wires to RWAL valve and
pressure differential switch on combination valve.
(9) Fill and bleed brake system. Refer to proce­
dures in appropriate antilock brake section.
POWER BRAKE VACUUM P U i P (DIESEL ENGINE)
REMOVAL
(1) Disconnect battery negative cable.
(2) Position drain pan under power steering pump.
(3) Disconnect vacuum and steering pump hoses
(Fig. 33).
(4) Disconnect oil pressure sender wires and
remove sending unit (Fig. 34).
Fig. 33 Vacuum And Steering Pump Hose
Connections
PUMP . ENGINE BLOCK
J 9 1
Fig. 34 Oil Pressure Sender Location