Updating Of Firmware Using An External Memory (Function Code 28) - Brother DCPJ525W Service Manual

1.4.10 Updating of Firmware Using an External Memory (Function code 28)

Function
This function updates firmware stored in the flash ROM on the main PCB using an external
memory (memory card or USB flash memory). It enables updating of firmware without
connecting the machine to a PC.
TIP: For instructions on how to update firmware when the main PCB has been replaced or for
operations using a PC, refer to
Operating Procedure
(1) Switch your PC ON and insert an external memory.
(2) Create a folder named "BROTHER" in the top layer of the external memory's directory and
copy the firmware file having the extension .pjl into that folder.
Note: Before copying, check that the file name of the firmware matches with your
machine. Be sure to save only one firmware file having the extension .pjl in the
"BROTHER" folder. Otherwise, the firmware cannot be updated correctly.
Tip: If a firmware file not matching the machine is used, the firmware cannot be updated,
but note that you can superficially continue the operation until step (5) below without any
error.
Tip: For instructions on how to obtain the firmware file, refer to
(3) Remove the external memory from the PC and insert it into the machine in the initial stage
of the maintenance mode.
Note: Do not insert more than one external memory at a time.
Note: When performing this procedure for any other machine with the same external
memory, delete the data previously stored in the external memory.
(4) On the machine, press the 2 and 8 keys in this order.
The file name ********.pjl appears on the LCD. Check that ******** is identical with the
file name that has been copied into the external memory.
(5) Press the Black Start (Mono Start) key to start updating.
The "Receiving Data" appears on the LCD, and after a while, it changes to "Program
Updating."
Note: Pressing the Color Start key in this step does not start updating.
Note: Never remove the external memory from the machine when updating is in progress.
(6) Updating will complete in a few minutes, and the machine automatically restarts and
returns to the standby state.
Remove the external memory from the machine and store it in a safe place.
Note 1: If any of the error messages listed below appears, press the Stop/Exit key, and the
machine returns to the initial stage of the maintenance mode.
Error Message
Card is used
Insert Card
No file
Too many files
Card Error
Note 2: After the completion of firmware updating, a file named "mfu-send.log" (which stores
the execution log) is created in the layer right below the "BROTHER" folder.
Chapter 4, Section
The external memory is being used by another operation.
No external memory is inserted.
Invalid file name
There is more than one file having the extension .pjl in the
folder.
External memory defective
5-21
2.1.
Chapter 4, Section
Cause
2.1.
Confidential