Control Panel Assy - Brother DCPJ525W Service Manual

9.7

Control Panel ASSY

(1) Remove three screws "a" from the control panel ASSY.
(2) Slightly pull up the rear end of the control panel ASSY and press the front end to the rear to
separate the ASSY from the upper cover.
Note: Do not pull the control panel ASSY away from the machine since it is connected to
the machine with harnesses.
(3) Slightly lift up the control panel ASSY, disconnect the panel harness and touch panel
*1
harness
(4) Disconnect the LCD flat cable from the main PCB.
Note: After disconnecting the flat cable, check that it is not damaged at its end or short-
circuited. When connecting the flat cable, do not insert it at an angle. After insertion, check
again that it is not at an angle.
(5) Models with touch panel Release the grounding wire
remove it from the cable guides.
MFC with touch panel
"a"
Upper cover
Assembling Notes:
• Route the panel harness, touch panel harness
(circled with a dashed line).
• After mounting the control panel ASSY, check that there is no gap between the front end of
the control panel ASSY and that of the upper cover.
from the main PCB, and release them from their cable guides.
"a"
Panel harness
*1
LCD flat cable
Touch panel harness *
*1
and grounding wire
3-68
*1 For models with touch panel
by removing screw "b"
"a"
Control panel ASSY
"b" *
Grounding wire *
1
"a": Taptite, cup B M3x10
"b": Taptite, cup S M3x6*
(3_064_MFCJ825DW)
*1
through cable guides
*1
and
1
1
1
Confidential