Appendix 3 Installing The Maintenance Printer Driver - Brother DCPJ525W Service Manual

APPENDIX 3. INSTALLING THE MAINTENANCE PRINTER DRIVER
To identify machines connected via USB direct interface, the PC requires the corresponding
driver for the virtual USB device. If you connect any number of machines to your PC, the same
number of virtual USB devices will be automatically configured on your PC. To prevent many
virtual USB devices from being configured, use the unique driver installation procedure
described below that enables your PC to identify terminals via one single virtual USB device.
NOTE: Once this installation procedure is carried out for a PC, no more driver/software
installation will be required for that PC to identify machines. If the Brother Maintenance USB
Printer driver has been already installed to your PC according to this procedure, skip this
section.
Windows 2000/Windows XP
(1) Check that the power cord of the machine is unplugged from the electrical outlet.
Disconnect the USB cable that connects the machine with your PC.
(2) Turn on your PC.
(3) Plug the power cord of the machine into an electrical outlet.
(4) Switch the machine to the maintenance mode. (Refer to
(5) Connect the machine to your PC using a USB cable.
The following window appears.
(6) The following screen appears, indicating the detection of new hardware device by the
system. Select "No, not this time." And click Next.
Chapter
App. 3-1
5.)
Confidential