Checking The Transaxle/Hydraulic-Fluid Level; Checking The High Flow Hydraulic-Fluid Level - Toro 07385 Workman HDX-D Operator's Manual

3. If the coolant is low, remove the reserve tank cap
and add a 50/50 mixture of water and permanent
ethylene-glycol antifreeze.
Note: Do not overfill the reserve tank with coolant.
4. Install the reserve-tank cap.
Checking the
Transaxle/Hydraulic-Fluid
Level
Service Interval: Before each use or daily (check the fluid
level before the engine is first started and
every 8 hours or daily, thereafter.)
Transaxle fluid type: Dexron III ATF
1. Position the machine on a level surface.
2. Clean the area around the dipstick
1. Dipstick
3. Unscrew the dipstick from the top of the transaxle and
wipe it with a clean rag.
4. Screw the dipstick into the transaxle and ensure that
it is fully seated.
5. Unscrew the dipstick and check the fluid level.
Note: The fluid should be up to top of the flat portion
of the dipstick.
6. If the level is low, add enough of the specified fluid to
achieve the proper level.
(Figure 19).
Figure 19
Checking the High Flow
Hydraulic-Fluid Level
TC Models Only
Service Interval: Before each use or daily (check the level of
hydraulic fluid before the engine is first
started, and daily thereafter).
Hydraulic-fluid type: Toro Premium All Season
Hydraulic Fluid (Available in 5-gallon pails or 55-gallon
drums. See parts catalog or Toro distributor for part
numbers.)
Alternate fluids: If the Toro fluid is not available, another
conventional petroleum–based fluid may be used provided
it meets the following material properties and industry
specifications. Consult with your lubricant distributor to
identify a satisfactory product.
Note: Toro will not assume responsibility for damage
caused by improper substitutions, so use only products
from reputable manufacturers who will stand behind their
recommendation.
High Viscosity Index/Low Pour Point Antiwear
Hydraulic Fluid, ISO VG 46
Material Properties:
•
Viscosity—ASTM D445 cSt @ 40ºC: 44 to 48/cSt @
100ºC: 7.9 to 8.5
•
Viscosity Index, ASTM D2270—140 to 152
•
Pour Point, ASTM D97— -35ºF to -46ºF
•
FZG, Fail stage—11 or better
•
Water content (new fluid)—500 ppm (maximum)
Industry Specifications:
Vickers I-286-S, Vickers M-2950-S, Denison HF-0, Vickers
35 VQ 25 (Eaton ATS373-C)
1. Clean the area around the filler neck and the cap of the
hydraulic tank (Figure
2. Remove the cap from the filler neck.
1. Cap
3. Remove the dipstick
and wipe it with a clean rag.
23
20).
Figure 20
(Figure 20) from the filler neck