Removing The Full Bed; Installing The Full Bed - Toro 07385 Workman HDX-D Operator's Manual

Removing the Full Bed

1. Start the engine, engage the hydraulic-lift lever, and
lower the bed until the cylinders are loose in the slots.
2. Release the lift lever and turn off the engine.
3. Remove the lynch pins from the outer ends of the
cylinder rod clevis pins
1. Cylinder rod end
2. Bed-mounting plate
3. Clevis pin
4. Remove the clevis pins securing the cylinder rod ends
to the bed-mounting plates by pushing the pins toward
the inside (Figure 33).
5. Remove the lynch pins and clevis pins securing the
pivot brackets to the frame channels
6. Lift the bed off the machine.
Important: The full bed weighs approximately
148 kg (325 lb), so do not try to install or remove
it by yourself.
Use an overhead hoist or get the help of 2 or 3
other people.
7. Store the cylinders in the storage clips.
8. Engage the hydraulic-lift-lock lever on the machine to
prevent accidental extension of the lift cylinders.
(Figure 33).
Figure 33
4. Lynch pin
5. Rear slots (full bed)
6. Front slots (2/3 bed)
(Figure

Installing the Full Bed

Note: If the bed sides will be installed on the flat bed, it is
easier to install them before installing the bed on the machine.
Note: Ensure that the rear pivot plates are bolted to the
bed frame/channel so that the lower end angles to the rear
(Figure 34).
1. Left, rear corner of bed
2. Machine frame channel
3. Pivot plate
Important: The full bed weighs approximately 148 kg
(325 lb), so do not try to install or remove it by yourself.
Use an overhead hoist or get the help of 2 or 3 other
people.
Note: Ensure that the spacer brackets and wear blocks
33).
(Figure 35) are installed with the carriage-bolt heads
positioned inside the machine.
36
Figure 34
4. Clevis pin
5. Lynch pin