Setup; Installing The Steering Wheel; Installing The Rollover-Protection System (Rops) - Toro 07385 Workman HDX-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right side of the machine from
the normal operating position.
1

Installing the Steering Wheel

TC Models Only
Parts needed for this procedure:
1 Steering wheel
Procedure
1. Release the tabs on the back of the steering wheel that
hold the center cover in place, and remove the cover
from the hub of the steering wheel.
2. Remove the locknut and washer from the steering shaft.
3. Slide the steering wheel and washer onto the shaft.
Note: Align the steering wheel on the shaft so that
the cross beam is horizontal when the tires are pointed
straight ahead and the thicker spoke of the steering
wheel is downward.
Note: The dust cover is positioned onto the steering
shaft at the factory.
4. Secure the steering wheel to the shaft with the locknut
and torque the locknut to 24 to 29 N∙m (18 to 22 ft-lb)
as shown in Figure
Description
Steering wheel
ROPS frame
Bolt (1/2 inch)
No parts required
3.
Qty.
Install the steering wheel (TC models
1
only).
1
Mount the Rollover-Protection System
(ROPS).
6
Check the engine oil, the
–
transaxle/hydraulic fluid, and the
brake-fluid levels.
1. Steering shaft
2. Dust cover
3. Steering wheel
4. Tab slots in wheel
5. Align the tabs of the cover with the slots in the steering
wheel, and snap the cover onto the steering-wheel hub
(Figure 3).
13
Use
Figure 3
5. Washer
6. Locknut
7. Cover
8. Tabs in cover