Removing The Hood; Installing The Hood - Toro 07385 Workman HDX-D Operator's Manual

Figure 37
1. Rear jacking points

Removing the Hood

1. While grasping the hood in the headlight openings, lift
up the hood to release the lower mounting tabs from
the frame slots (Figure
Figure 38
1. Hood
2. Pivot the bottom of the hood upward until the top
mounting tabs can be pulled from the frame slots
(Figure 38).
3. Pivot the top of the hood forward, and unplug the wire
connectors from the head lights
4. Remove the hood.
38).
(Figure 38).

Installing the Hood

1. Connect the lights.
2. Insert the top mounting tabs into the frame slots.
3. Insert the lower mounting tabs into the frame slots.
4. Ensure that the hood is fully engaged in the top, sides
and bottom grooves.
38