Fuel System Maintenance; Checking The Fuel Lines And Connections; Servicing The Fuel Filter/Water Separator - Toro 07385 Workman HDX-D Operator's Manual

3. When the oil stops, install the drain plug.
4. Remove the oil filter
5. Apply a light coat of clean oil to the new filter seal
before screwing it on.
6. Screw the filter on until the gasket contacts the
mounting plate, then tighten the filter 1/2 to 2/3 of
a turn.
Note: Do not overtighten.
7. Add the specified oil to the crankcase.
(Figure 45).
Fuel System
Maintenance
Checking the Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever comes
first)
Every 1,000 hours/Every 2 years (whichever comes
first)
Inspect the fuel lines and connections for deterioration,
damage, or loose connections.
Servicing the Fuel Filter/Water
Separator
Draining the Fuel Filter/Water Separator
Service Interval: Before each use or daily—Drain water
or other contaminants from the water
separator.
1. Place a clean container under the fuel filter
2. Loosen the drain plug on the bottom of the filter
canister.
1. Filter canister
3. Tighten the drain plug on the bottom of the filter
canister.
42
(Figure
Figure 46
46).