Toro 07385 Workman HDX-D Operator's Manual page 5

•
If fuel is spilled on clothing, change clothing immediately.
•
Never overfill the fuel tank. Replace the fuel cap and
tighten it securely.
Operation
•
The operator and passenger must use seat belts and
remain seated whenever the machine is in motion. Keep
both hands on the steering wheel, whenever possible, and
the passenger should use the hand holds provided. Keep
your arms and legs within the vehicle body at all times.
Never carry passengers in the box or on attachments.
Remember, your passenger may not be expecting you to
brake or turn, and may not be ready.
•
Do not overload your machine. The name plate (located
under the middle of the dash) shows the load limits for
the machine. Never overfill attachments or exceed the
machine maximum gross vehicle weight (GVW).
•
When starting the engine:
– Sit on the operator's seat and ensure that the parking
brake is engaged.
– Disengage the PTO (if so equipped) and return the
hand-throttle lever to the O
– Make sure that the hydraulic-lift lever is in the center
position.
– Move the shift lever to the N
press the clutch pedal.
– Keep your foot off the accelerator pedal.
– Turn ignition switch to the O
glow-plug indicator goes off, the engine is ready to
start.
– Turn the ignition key to the S
•
Failure to operate machine safely may result in an
accident, tipping over the machine, and/or serious injury
or death. To prevent tipping or loss of control, take the
following precautions:
– Use extreme caution, reduce your speed, and maintain
a safe distance around sand traps, ditches, creeks,
ramps, any unfamiliar areas, or other hazards.
– Watch for holes or other hidden hazards.
– Use caution when operating the machine on a steep
slope. Normally, travel straight up and down slopes.
Reduce your speed when making sharp turns or
when turning on hillsides. Avoid turning on hillsides
whenever possible.
– Use extra caution when operating the vehicle on
wet surfaces, at higher speeds, or with a full load.
Stopping time will increase with a full load. Shift into
a lower gear before starting up or down a hill.
– When loading the bed, distribute the load evenly.
Use extra caution if the load exceeds the dimensions
of the machine/bed. Operate the vehicle with extra
position (if equipped).
FF
position and
EUTRAL
position. When the
N
position.
TART
caution when handling off-center loads that cannot
be centered. Keep loads balanced and secure to
prevent them from shifting.
– Avoid sudden stops and starts. Do not go from
reverse to forward or forward to reverse without first
coming to a complete stop.
– Do not attempt sharp turns or abrupt maneuvers or
other unsafe driving actions that may cause a loss of
machine control.
– When dumping, do not let anyone stand behind the
machine, and do not dump the load on anyone's feet.
Release the tailgate latches from the side of box, not
from behind.
– Keep all bystanders away. Before backing up, look to
the rear and ensure that no one is behind the machine.
Back up slowly.
– Watch out for traffic when near or crossing roads.
Always yield the right of way to pedestrians and other
machines. This machine is not designed for use on
streets or highways. Always signal your turns or stop
early enough so other persons know what you plan to
do. Obey all traffic rules and regulations.
– Never operate the machine in or near an area where
there is dust or fumes in the air which are explosive.
The electrical and exhaust systems of the machine can
produce sparks capable of igniting explosive materials.
– Always watch out for and avoid low overhangs such
as tree limbs, door jambs, overhead walkways, etc.
Make sure that there is enough room overhead to
easily clear the machine and your head.
– If you are ever unsure about safe operation, stop
work, and ask your supervisor.
•
Do not touch the engine, transaxle, radiator, muffler, or
muffler manifold while the engine is running or soon
after it has stopped, because these areas may be hot
enough to cause burns.
•
If the machine ever vibrates abnormally, stop immediately,
shut the engine off, wait for all motion to stop, and
inspect for damage. Repair all damage before resuming
operation.
•
Before getting off the seat:
1. Stop the machine.
2. Set the parking brake.
3. Turn the ignition key to the O
4. Remove the ignition key.
Note: If the machine is on an incline, block the
wheels after getting off the machine.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
5
position.
FF