Checking The Fluid Levels - Toro 07385 Workman HDX-D Operator's Manual

2
Installing the
Rollover-Protection System
(ROPS)
Parts needed for this procedure:
1 ROPS frame
6 Bolt (1/2 inch)
Procedure
1. Align each side of the ROPS with the mounting holes
in the frame at each side of the vehicle as shown in
Figure 4.
1. ROPS-mounting bracket
2. Secure each side of the ROPS to frame with 3 flanged
bolts (1/2 x 1-1/4 inches) and tighten the bolts to 115
N∙m (85 ft-lb).
Figure 4
2. Flanged bolts (1/2 x 1-1/4
inches)
3

Checking the Fluid Levels

No Parts Required
Procedure
1. Check the engine-oil level before and after the engine
is first started; refer to
(page 20).
2. Check the transaxle/hydraulic-fluid level before
the engine is first started; refer to
Transaxle/Hydraulic-Fluid Level (page
3. Check the brake-fluid level before the engine is first
started; refer to
25).
14
Checking the Engine-Oil Level
Checking the
23).
Checking the Brake-Fluid Level (page