Premaintenance Procedures; Using The Bed Support - Toro 07385 Workman HDX-D Operator's Manual

Premaintenance
Procedures
Many of the subjects covered in this maintenance section
require raising and lowering the bed. The following
precautions must be taken or serious injury or death could
result.
WARNING
A raised bed full of material without the proper
safety support rod may lower unexpectedly.
Working under an unsupported raised bed may
cause injury to you or others.
• Before servicing or making adjustments to the
machine, shut off the engine, set the parking
brake, and remove the key from the ignition
switch.
• Remove any load material from the bed or other
attachment and insert the safety support on
a fully extended cylinder rod before working
under a raised bed.

Using the Bed Support

Important: Always install or remove the bed support
from the outside of the bed.
1. Raise the bed until the lift cylinders are fully extended.
2. Remove the bed support from the storage brackets on
the back of the ROPS panel
Figure 31
1. Bed support
(Figure 31).
3. Push the bed support onto the cylinder rod, ensuring
that the support end tabs rest on the end of the cylinder
barrel, and on the cylinder rod end
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder and insert it
into the brackets on the back of the ROPS panel.
Important: Do not try to lower the bed with the
bed-safety support on the cylinder.
35
(Figure 32).
Figure 32
3. Bed