Hydraulic System - Toro 07385 Workman HDX-D Operator's Manual

you must remove the load and box (attachment) to service
the engine or transaxle.
Raising the Cargo Box by Jumping the

Hydraulic System

CAUTION
A raised bed full of material without the proper
safety support rod may lower unexpectedly.
Working under an unsupported raised bed may
cause injury to you or others.
• Before servicing or making adjustments to the
machine, shut off the engine, set the parking
brake, and remove the key from the ignition
switch.
• Remove any load material from the bed or other
attachment and insert the safety support on
a fully extended cylinder rod before working
under a raised bed.
You will need 2 hydraulic hoses, each with a male and
female quick coupler, that fit the vehicle couplers, to
perform this operation.
1. Back another machine up to the rear of the disabled
machine.
Important: The machine hydraulic system uses
Dexron III ATF. To avoid system contamination,
make sure that the vehicle used to jump the
hydraulic system uses an equivalent fluid.
2. On both machine, disconnect the 2 quick-coupler
hoses from the hoses secured to the coupler bracket
(Figure 75).
1. Quick-coupler hose A
2. Quick-coupler hose B
Figure 75
3. On the disabled machine, connect the 2 jumper hoses
to the hoses that were disconnected
4. Cap the unused fittings.
1. Disconnected hoses
5. On the other machine, connect the 2 hoses to the
coupler still in the coupler bracket (connect the top
hose to the top coupler and the bottom hose to the
bottom coupler)
6. Cap the unused fittings.
G019543
1. Jumper hoses
7. Keep all bystanders away from the machines.
8. Start the second machine, and move the lift lever to the
raise position which will raise the disabled cargo box.
9. Move the hydraulic-lift lever to the N
and engage the lift-lever lock.
10. Install the bed support onto the extended lift cylinder;
refer to Using the Bed Support (page
Note: With both the machine turned off, move the lift
lever back and forth to remove the system pressure and
ease the disconnection of the quick couplers.
11. After completing the operation, remove the jumper
hoses and connect the hydraulic hoses to both
machines.
Important: Check the hydraulic fluid levels, in
both vehicles, before resuming operation.
55
(Figure
Figure 76
2. Jumper hoses
(Figure 77).
1
Figure 77
EUTRAL
35).
76).
position,