Lubrication; Greasing The Bearings And Bushings - Toro 07385 Workman HDX-D Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 100 hours (lubricate more frequently
in heavy duty applications).
The machine has grease fittings that must be lubricated
regularly with No. 2 lithium grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2), pivot mounts (2) and steering
cylinder (2) as shown in
•
Spring tower (2) as shown in
•
Clutch (1), accelerator (1), and brake (1) as shown in
Figure 41
•
U-joint (18) and 4-wheel-drive shaft (3) as shown in
Figure 42
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 39
Figure 39
Figure 40
39
Figure 40
Figure 41