Table of Contents
Advertisement
SERVICE WORK ON THE ENGINE
Adding engine oil
16.4
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
–
Push oil screen
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
B01127-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
B01131-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
B01130-10
–
Remove the oil filler plug
engine oil.
Engine oil
–
Install and tighten the oil filler plug with the O-ring.
B01119-11
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Follow-up work
–
Install the engine guard. (
–
Check the engine oil level. (
with the O-rings onto a pin wrench.
3
with the O-ring.
2
M20x1.5
with the magnet and a new seal ring.
1
M12x1.5
M6
with the O-ring from the clutch cover and fill up with
7
1.20 l (1.27 qt.)
Engine oil (SAE 10W/50) (
Alternative engine
oil
p. 58)
p. 85)
87
15 Nm
(11.1 lbf ft)
20 Nm
(14.8 lbf ft)
.
6
10 Nm (7.4 lbf ft)
p. 103)
Engine oil
(SAE 10W/60)
(00062010035)
(
p. 103)
Advertisement
Table of Contents
