ELECTRICAL SYSTEM
Checking the headlight setting
13.9
A
0 0 A
Adjusting the headlight range
13.10
Changing the speedometer battery
13.11
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
B
0 0 B
B
–
Position the vehicle vertically a distance
Guideline
Distance
A
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. (
Preliminary work
–
Check the headlight setting. (
Main work
–
Adjust the beam distance of the headlight by turning screw
Guideline
For a motorcycle with rider, the light/dark boundary must be exactly on the lower
mark (the mark is created in: Checking the headlight setting).
Info
Turn clockwise to increase the headlight range, turn counterclockwise to
reduce the headlight range.
B01043-10
A change in weight on the vehicle may require a correction of the headlight
range.
Preliminary work
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer out of the bracket from above.
B01133-10
–
Using a coin, turn locking cap
–
Remove speedometer battery
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) (
–
Check that the O-ring of the locking cap is seated properly.
B01134-10
under the first mark.
B
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 78)
p. 78)
.
1
counterclockwise all the way and remove it.
2
.
3
p. 98)
.
1
p. 76)
78