SERVICE WORK ON THE CHASSIS
Removing the main silencer
10.25
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Installing the main silencer
10.26
Changing the glass fiber yarn filling of the main silencer
10.27
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Info
Over a period, the fibers of the glass fiber yarn vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
The operations are the same for the left and right sides.
–
Clean the air filter housing.
–
Check the intake flange for damage and ensure it is firmly seated.
Follow-up work
–
Install the air filter.
–
Install the air filter housing.
–
Lock the seat. (
–
Disconnect the lambda sensor connector.
–
Detach springs
–
Remove screws
B01067-10
–
Position the main silencer. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Attach springs
–
Plug in the lambda sensor connector.
B01066-10
Preliminary work
–
Remove the main silencer. (
(
p. 46)
x
(
p. 45)
x
p. 45)
.
1
and take off the main silencer.
2
M8
.
2
x
p. 47)
47
.
1
25 Nm
(18.4 lbf ft)