SERVICE WORK ON THE CHASSIS
Checking for chain dirt accumulation
10.30
–
Position the fuel tank.
–
Position the intake flange on the throttle valve body.
–
Tighten hose clamp
B01077-11
–
Plug in connector
–
Position engine breather hose
B01076-11
–
Mount and tighten screws
Guideline
Screw, fuel tank
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Mount the fuel tank breather.
B01075-11
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
–
Remove the wash cap set. Lubricate the O-ring and connect plug-in connection
of the fuel line.
Info
B01079-10
Route the cable and fuel line at a safe distance from the exhaust system.
Subsequent work
–
Lock the seat. (
–
Check the chain for coarse dirt accumulation.
»
If the chain is very dirty:
–
Clean the chain. (
400678-01
.
2
.
3
.
4
on both sides.
5
M8
.
6
M6
p. 45)
p. 51)
50
15 Nm
(11.1 lbf ft)
10 Nm (7.4 lbf ft)
7