SERVICE WORK ON THE CHASSIS
Removing the lower triple clamp
10.9
Installing the lower triple clamp
10.10
0 0
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
B01039-11
x
Preliminary work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
Main work
–
Open the cable holder in front of the radiator and detach the wiring harness.
–
Loosen screw
–
Remove screw
aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
B01056-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
B01057-10
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
B01058-10
(
p. 68)
x
(
p. 38)
x
p. 44)
.
1
, take off the upper triple clamp with the handlebar and set it
2
. Remove protective ring
3
4
p. 105)
1
and O-ring
.
2
3
M6
10 Nm (7.4 lbf ft)
p. 76)
p. 37)
.
is correctly positioned.
40
.
2
.
3