Wheels, Tires; Removing The Front Wheel; Installing The Front Wheel - KTM Freeride 350 Owner's Manual

WHEELS, TIRES

Removing the front wheel

12.1

Installing the front wheel

12.2
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
x
Preliminary work
–
Raise the motorcycle with the lift stand. (
Main work
–
Remove screw
–
Release screws
B01044-10
–
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Do not pull the hand brake lever when the front wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
B01045-10
–
Remove spacers
B01046-10
x
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
B01046-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
–
Remove the motorcycle from the lift stand. (
B01044-11
.
1
.
2
.
3
x
and contact surface
1
p. 105)
.
2
M20x1.5
p. 37)
of the spacers.
A
35 Nm
(25.8 lbf ft)
p. 37)
68