SERVICE WORK ON THE CHASSIS
Removing the fork protector
10.7
Installing the fork protector
10.8
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B01054-11
–
Position brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
B01105-11
Subsequent work
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
x
–
Remove screws
–
Remove screws
B01039-10
–
Remove screws
B01040-10
x
–
Position the fork protection on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
B01040-11
.
2
M8
.
3
M8
M8
.
5
x
(
p. 68)
p. 78)
. Take off the clamp.
1
on the left fork leg. Take off the fork protector.
2
on the right fork leg. Take off the fork protector.
3
M6
22 Nm
(16.2 lbf ft)
18 Nm
(13.3 lbf ft)
.
4
25 Nm
Loctite
®
243™
(18.4 lbf ft)
p. 76)
1
10 Nm (7.4 lbf ft)
39
.
6
.