SERVICE WORK ON THE CHASSIS
Correcting the fluid level of the hydraulic clutch
10.43
Info
The fluid level rises with increasing wear of the clutch facing discs.
Changing the hydraulic clutch fluid
10.44
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level below container rim
»
If the fluid level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
Brake fluid DOT 4 / DOT 5.1 (
B01082-11
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
x
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
B01082-11
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
.
4
B01083-10
–
Remove screw
–
Inject the liquid into the system until it escapes from opening
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Mount and tighten screw
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
B01084-10
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
.
1
with membrane
.
2
3
4 mm (0.16 in)
p. 103)
.
1
with membrane
.
2
3
with the appropriate hydraulic fluid.
4
p. 103)
with the O-ring.
6
with the O-ring.
6
4 mm (0.16 in)
and mount bleeding
5
of the master
A
57