Monitor Wireless Stations - NETGEAR WAC720 Reference Manual

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Setting
Current Wireless Settings for 802.11b, 802.11g, or 802.11ng
and
Current Wireless Settings for 802.11a or 802.11na
Note: The section heading depends on the configured wireless mode.
Access Point Mode
Channel / Frequency
Rogue AP Detection

Monitor Wireless Stations

The Wireless Stations page contains the Available Wireless Stations table. This table shows
all IP devices that are associated with the wireless access point in the wireless network that
is defined by the wireless network name (SSID). The table headings indicate the wireless
modes (802.11bg, 802.11ng, or 802.11bgn for the 2.4 GHz band and 802.11a, 802.11na or
802.11ac for the 5 GHz band).
Note: A wireless network can include multiple wireless access points, all
using the same network name (SSID). This uniformity extends the
reach of the wireless network and allows users to roam from one
wireless access point to another, providing seamless network
connectivity. Under these circumstances, be aware that the Available
Wireless Stations table includes only the stations associated with this
wireless access point.
Description
The operating mode of the wireless access point. One of the following modes is
indicated:
• Access Point
• Point-to-Point Bridge
• Point-to-Point Bridge with Access Point
• Multi-Point Bridge with/without client association
For information about how to change the mode, see
on page 91.
The channel that the wireless port is using. For information about how to change
the channel and frequency, see
page 20 and Configure 802.11a/a-na-ac Wireless Settings
Enabled indicates that rogue AP detection is enabled. Disabled indicates that it
is not.
Management and Monitoring
64
Configure Wireless Bridging
Configure 802.11bg/ng/bgn Wireless Settings on
on page 22.