Configure A New Qos Policy - NETGEAR WAC720 Reference Manual

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
• IP protocol. Indicates the protocol field in the IP header.
• EtherType. Indicates the EtherType field in Ethernet-II frame header.
• Source MAC. Indicates the source MAC address in Ethernet-II frame header.
• Destination MAC. Indicates the destination MAC address in Ethernet-II frame header.
• Source IP. Indicates the source IP address in the IP header.
• Destination IP. Indicates the destination IP address in the IP header.
• Source port. Indicates the source port number in the port header.
• Destination port. Indicates the destination port number in the port header.
For each classification in a QoS policy, you can configure rate limiting by specifying the
maximum bit rate and maximum burst rate. Packets that exceed the maximum bit rate are
retained in the traffic queue and are processed when transmission falls again below the
maximum bit rate. You can also configure the overall maximum bit rate and maximum burst
rate for the entire wireless interface.

Configure a New QoS Policy

You can configure up to eight QoS policies.
To configure a new QoS policy:

1. Select Configuration > Wireless > Advanced > QoS Policies.
2. From the Create Policy menu, select NEW.
If you did not yet set up any QoS policies, NEW is the only selection possible.
Advanced Configuration
84