Factory Default Settings - NETGEAR WAC720 Reference Manual

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Table 4. Technical specifications (continued)
Feature
Status LEDs
Electrical and Physical Specifications
Power adapter
Physical specifications
Environmental
specifications
Electromagnetic
compliance

Factory Default Settings

You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately five seconds (until the Test LED blinks rapidly). This returns the wireless
access point to the factory configuration settings that are shown in the following table.
Note: Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
Table 5. Default configuration settings
Feature
Login for management and configuration
LAN IPv4 management address
Subnet mask for IPv4 management address
LAN IPv6 management address
Description
• Power/Test LED
• Activity LED
• Ethernet LAN
• Wireless LAN (2.4 GHz and 5 GHz)
12 VDC, 2.5A; plug is localized to country of sale
• Dimensions (h x w x d): 197.3 x 197.3 x 40 mm (7.76 x 7.76 x 1.57 in.)
• Weight: 762 g (1.6 lb)
Operating temperature: 0 to 40°C (32 to 131°F)
Operating humidity: 10–90%, noncondensing
• FCC Part 15 SubPart B
• FCC Part 15 SubPart C
• FCC Part 15 SubPart E
• CE
• C-TICK
Supplemental Information
105
Description
192.168.0.100
255.255.255.0
2001::21c:c0ff:fe69