NETGEAR WAC720 Reference Manual page 63

ProSAFE Dual-Band Wireless AC Access Points WAC720 and WAC730
Setting
Country/Region
Firmware Version
Serial Number
Current Time
AP Uptime
Current IPv4 Settings
For information about how to change any of these IP settings, see
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current IPv6 Settings
For information about how to change any of these IP settings, see
IPv6 Address
Prefix Length
Dynamic IPv6 Address
Default Gateway
LAN IPv6 Link-Local
Address
DHCP Client
Description
The country or region for which the wireless access point is licensed for use. For
information about how to change the country or region, see
General System Settings and Time Settings
Note: It might not be legal to operate this wireless access point in a country or
region other than one of those identified in this field.
The version of the firmware that is currently installed.
The serial number of the wireless access point.
The current time. For information about how to change the time settings, see
Configure Basic General System Settings and Time Settings
The length of time since the access point became active.
The IPv4 address of the wireless access point.
The subnet mask for the address of the wireless access point.
The default IPv4 gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCPv4
server on your LAN network. Disabled indicates a static IP configuration.
The default IPv6 address of the wireless access point.
The prefix length for the address of the wireless access point.
The dynamically assigned IPbv6 address if the DHCPv6 server has the stateful
option enabled.
The default IPv6 gateway for the wireless access point communication.
This is an automatically generated IPv6 address that uses the IPv4 address in
the interface portion of its address.
Enabled indicates that the current IP address was obtained from a DHCPv6
server on your LAN network. Disabled indicates a static IP configuration.
Management and Monitoring
63
Configure Basic
on page 16.
on page 16.
Configure the IPv4 Settings
Configure IPv6 Settings on page 74.
on page 18.