Adding A Qos Queue - ZyXEL Communications AMG1302-T11C User Manual

Table 43 Network Setting > QoS > Queue
LABEL
Rate Limit
Modify

10.3.1 Adding a QoS Queue

Click the edit icon in the Queue Setup screen to configure a queue.
Figure 64 Queue Setup: Edit
The following table describes the labels in this screen.
Table 44 Queue Setup: Edit
LABEL
Active
Name
Interface
Priority
Weight
Rate Limit
OK
Cancel
Chapter 10 Quality of Service (QoS)
DESCRIPTION
This shows the maximum transmission rate allowed for traffic on this queue.
Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue.
Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
Select the priority level (from 1 to 3) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority
queues gets through faster while traffic in lower priority queues is dropped if the network is
congested.
Select the weight (from 1 to 8) of this queue.
If two queues have the same priority level, the AMG1302-T11C divides the bandwidth
across the queues according to their weights. Queues with larger weights get more
bandwidth than queues with smaller weights.
Specify the maximum transmission rate (in Kbps) allowed for traffic on this queue.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
AMG1302-T11C User's Guide
140