Ipv6 Static Route - ZyXEL Communications AMG1302-T11C User Manual

Figure 58 Network Setting > Static Route Add/Edit
The following table describes the labels in this screen.
Table 39 Network Setting > Static Route Add/Edit
LABEL
Destination IP
Address
IP Subnet Mask
Use Gateway IP
Address
Gateway IP
Address
Use Interface
Metric
OK
Cancel

9.3 IPv6 Static Route

Use this screen to view the IPv6 static route rules. Click Network Setting > Static Route > IPv6
Static Route to open the IPv6 Static Route screen.
Figure 59 Network Setting > Static Route > IPv6 Static Route
Chapter 9 Static Route
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
Enter the IP subnet mask here.
The gateway is a router or switch on the same network segment as the device's LAN or
WAN port. The gateway helps forward packets to their destinations.
If you want to use the gateway IP address, select Enable.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Select the WAN interface you want to use for this static route.
Enter the number of transmission hops (routers) that need to cross from the AMG1302-
T11C to the destination.
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1302-T11C User's Guide
134