ZyXEL Communications AMG1302-T11C User Manual page 208

Restore Configuration
Restore Configuration allows you to upload a new or previously saved configuration file from your
computer to your AMG1302-T11C.
Table 86 Restore Configuration
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse... to find it.
Browse... Click this to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Upload Click this to begin the upload process.
Reset Click this to reset your device settings back to the factory default.
Do not turn off the AMG1302-T11C while configuration file upload is in
progress.
After the AMG1302-T11C configuration has been restored successfully, the login screen appears.
Login again to restart the AMG1302-T11C.
The AMG1302-T11C automatically restarts in this time causing a temporary network disconnect. In
some operating systems, you may see the following icon on your desktop.
Figure 116 Network Temporarily Disconnected
If you restore the default configuration, you may need to change the IP address of your computer
to be in the same subnet as that of the default device IP address (192.168.1.1). See
page 231 for details on how to set up your computer's IP address.
If the upload was not successful, an error screen will appear. Click OK to go back to the
Configuration screen.
Reset to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the AMG1302-
T11C to its factory defaults. The following warning screen appears.
Figure 117 Reset Warning Message
Wait until the AMG1302-T11C's login screen appears. You can also press the RESET button on the
rear panel to reset the factory defaults of your AMG1302-T11C. Refer to
more information on the RESET button.
Chapter 26 Backup/Restore and Reboot
AMG1302-T11C User's Guide
208
Appendix B on
Section 1.7 on page 16 for