Adding A Qos Queue - ZyXEL Communications PX7511-B0 User Manual

Table 46 Network Setting > QoS > Queue Setup (continued)
LABEL
Buffer
Management
Rate Limit
Modify

10.4.1 Adding a QoS Queue

Click Add New Queue or the Edit icon in the Queue Setup screen to configure a queue.
Figure 85 Queue Setup: Add
The following table describes the labels in this screen.
Table 47 Queue Setup: Add
LABEL
Active
Name
Interface
Priority
Chapter 10 Quality of Service (QoS)
DESCRIPTION
This shows the queue management algorithm used for this queue.
Queue management algorithms determine how the Zyxel Device should handle packets when
it receives too many (network congestion).
This shows the maximum transmission rate allowed for traffic on this queue. Rate limit 0 means
there's no rate limit on this queue.
Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
DESCRIPTION
Click this switch to enable or disable the queue. When the switch turns blue
enabled. Otherwise, it is not.
Enter the descriptive name of this queue.
Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
Select the priority level (from 1 to 7) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority queues
gets through faster while traffic in lower priority queues is dropped if the network is congested.
PX7511-B0 User's Guide
150
, the function is