Configuring Static Route For Routing To Another Network - ZyXEL Communications AMG1302-T11C User Manual

The firewall rule you configured appears in the table. The AMG1302-T11C allows traffic from the
5
WAN to LAN if it matches port 123.
4.8 Configuring Static Route for Routing to Another
Network
In order to extend your Intranet and control traffic flowing directions, you may connect a router to
the AMG1302-T11C's LAN. The router may be used to separate two department networks. This
tutorial shows how to configure a static routing rule for two network routings.
In the following figure, router R is connected to the AMG1302-T11C's LAN. R connects to two
networks, N1 (192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from
computer A (in N1 network) to computer B (in N2 network), the traffic is sent to the AMG1302-
T11C's WAN default gateway by default. In this case, B will never receive the traffic.
N1
You need to specify a static routing rule on the AMG1302-T11C to specify R as the router in charge
of forwarding traffic to N2. In this case, the AMG1302-T11C routes traffic from A to R and then R
routes the traffic to B.
Chapter 4 Tutorials
A
AMG1302-T11C User's Guide
R
B
49
N2