Adding A Qos Queue - ZyXEL Communications SBG5500-A User Manual

Table 85 Network Setting > QoS > Queue Setup (continued)
LABEL
Multiple Entries
Turn Off
#
Status
Name
Interface
Priority
Weight
Buffer
Management
Rate Limit

11.3.1 Adding a QoS Queue

Click Add or the select an existing queue and click Edit icon in the Queue Setup screen to configure a
queue.
Figure 145 Queue Setup: Add/Edit
The following table describes the labels in this screen.
Table 86 Queue Setup: Add/Edit
LABEL
Enable
Name
Chapter 11 Bandwidth Management
DESCRIPTION
Select a queue and click this to disable it.
This is the index number of the queue entry.
This field displays whether the queue is active or not. A green ON button signifies that this queue
is active. A gray OFF button signifies that this queue is not active.
Click the slide button to turn on or turn off the queue.
This shows the descriptive name of this queue.
This shows the name of the SBG's interface through which traffic in this queue passes.
This shows the priority of this queue.
This shows the weight of this queue.
This shows the queue management algorithm used for this queue.
Queue management algorithms determine how the SBG should handle packets when it
receives too many (network congestion).
This shows the maximum transmission rate allowed for traffic on this queue.
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue. You can use up to 31 alphanumeric characters, it must
begin with a letter. The valid characters are [0-9][a-z] [A-Z][_-].
This field is not configurable if you are editing an existing queue.
SBG5500 Series User's Guide
198