The Wps Screen - ZyXEL Communications AMG1302-T11C User Manual

Figure 34 Network Setting > Wireless > MAC Authentication: Add/Edit
The following table describes the fields in this screen.
Table 23 Network Setting > Wireless > MAC Authentication: Add/Edit
LABEL
Mac Address
OK
Cancel

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your AMG1302-T11C.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The AMG1302-T11C applies the security settings configured in the General screen
(see
have set the security mode to WPA-PSK, WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Chapter 7 Wireless LAN
DESCRIPTION
Enter the MAC addresses of the wireless devices that are allowed or denied access to
the AMG1302-T11C in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
Section 7.10.8.3 on page 113
Section 7.2 on page
AMG1302-T11C User's Guide
88). If you want to use the WPS feature, make sure you
98
for more information about WPS.