ZyXEL Communications AMG1302-T11C User Manual page 30

After you configure the Internet access information, use the following screen to set up your wireless
LAN.
Check the Wireless Service box to enable wireless connection on the ZyXEL device.
5
Configure your wireless settings in this screen. Click Next.
6
Figure 13 Wireless Setup
The following table describes the labels in this screen.
Table 7 Wireless Setup
LABEL DESCRIPTION
Wireless Click this to enable or disable the wireless service on the ZyXEL device.
Service
Wireless Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
Network
If you change this field on the AMG1302-T11C, make sure all wireless stations use the same
Name(SSID)
SSID in order to access the network.
Channel The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a channel.
Selection Select a channel ID that is not already in use by a neighboring device.
Security Level Displays the security setting. To mofidy, see
Pre-Shared Key Enter a set of characters (8 to 63 characters or 64 hexadecimal digits [a-f, A-F, and 0-9]) for
the shared security key.
Back Click this to return to the previous screen without saving.
Next Click this to continue to the next wizard screen.
Close Click this to close the wizard screen without saving.
Note: The wireless stations and AMG1302-T11C must use the same SSID and channel ID
for wireless communication.
The configuration settings are saved and applied. Click Close to complete the setup.
7
Chapter 3 Quick Start Wizard
AMG1302-T11C User's Guide
30
Section 7.2 on page 88.