ZyXEL Communications AMG1302-T11C User Manual page 72

Table 11 Network Setting > Broadband > Internet Connection (continued)
LABEL DESCRIPTION
IPv6/IPv4 Dual Stack Select IPv4 if you want the AMG1302-T11C to run IPv4 only.
Select IPv4/IPv6 to allow the AMG1302-T11C to run IPv4 and IPv6 at the same
time.
Select IPv6 if you want the AMG1302-T11C to run IPv6 only.
This field is not available when you select IPoA in the Encapsulation field.
PPP Authentication The AMG1302-T11C supports PAP (Password Authentication Protocol) and CHAP
(Challenge Handshake Authentication Protocol). CHAP is more secure than PAP;
however, PAP is readily available on more platforms.
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
AUTO - Your AMG1302-T11C accepts either CHAP or PAP when requested by this
remote node.
CHAP - Your AMG1302-T11C accepts CHAP only.
PAP - Your AMG1302-T11C accepts PAP only.
Virtual Circuit ID VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. Refer to the appendix for more information.
VPI This option is available if you select Router in the Mode field.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI This option is available if you select Router in the Mode field.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management
of ATM traffic). Enter the VCI assigned to you.
Enable VLAN This option is available if you select Ethernet(ETH1) in the Line >Type field.
The AMG1302-T11C supports Ether WAN function: DSL users must connect an RJ11
cable to the DSL port (Default), while EtherWAN users must connect an RJ45 cable
into LAN port 1.
802.1Q VLAN ID The valid range for the VLAN ID (as assinged by your provider) is 5 to 4094.
IP Address
Obtain an IP Address This option is available if you select Router in the Mode field.
Automatically
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not
Static IP Address fixed; the ISP assigns you a different one each time you connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic IP address;
otherwise select Static IP Address and type your ISP assigned IP address in the IP
Address field and a gateway IP address (supplied by your ISP) below.
IPv6 Tunnel Mode Use IPv6 tunneling when the local network uses IPv6 and the ISP has an IPv4
network. When the AMG1302-T11C has an IPv4 WAN address and you set IPv6/IPv4
Dual Stack to IPv4 and select ENET ENCAP or PPPoE in the Encapsulation field,
you can enable IPv6 tunneling to encapsulate IPv6 packets in IPv4 packets to cross
the ISP's IPv4 network.
Select Disable to not allow IPv6 packets to cross IPv4 networks.
Select 6to4 to transmit IPv6 packets over an IPv4 network. A 6to4 relay router is
required to route 6to4 packets to a native IPv6 network.
Select 6rd to enable 6RD. IPv6 Rapid Deployment (6RD) is an IPv6 transitioning
process for the stateless tunneling of IPv6 over IPv4. Enable 6RD to tunnel IPv6 traffic
from the local network through the ISP's IPv4 network.
Relay Server Enter the IPv4 address of a 6to4 relay server, which helps forward packets between
6to4 networks and native IPv6 networks.
Chapter 6 Broadband
AMG1302-T11C User's Guide
72