Adding A Qos Queue - ZyXEL Communications EX3510-B1 User Manual

The following table describes the labels in this screen.
Table 47 Network Setting > QoS > Queue Setup
LABEL
Add New
Queue
#
Status
Name
Interface
Priority
Weight
Buffer
Management
Rate Limit
Modify

10.4.1 Adding a QoS Queue

Click Add New Queue or the Edit icon in the Queue Setup screen to configure a queue.
Figure 90 Queue Setup: Add
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Click this button to create a new queue entry.
This is the index number of the entry.
This field displays whether the queue is active or not. A yellow bulb signifies that this queue is
active. A gray bulb signifies that this queue is not active.
This shows the descriptive name of this queue.
This shows the name of the Zyxel Device's interface through which traffic in this queue passes.
This shows the priority of this queue. The lower the number, the higher the priority level.
This shows the weight of this queue.
This shows the queue management algorithm used for this queue.
Queue management algorithms determine how the Zyxel Device should handle packets when
it receives too many (network congestion).
This shows the maximum transmission rate allowed for traffic on this queue. Rate limit 0 means
there's no rate limit on this queue.
Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
EX3510-B1 User's Guide
151