Power On/Off Submenu - Fujitsu PRIMERGY RX200 S4 User Manual

7.2.9 Power On/Off Submenu

This submenu appears when selecting [Power On/Off] from the [Advanced] menu.
Use this submenu to configure the power on/off settings.
Advanced
Advanced System Configuration
Power Off Source
Software:
Power Button:
Power On Source
Remote:
LAN:
Wake up Timer:
Wake up Time:
Wake up Mode:
Power Failure Recovery:
Item
Power-Off Source
Software
Power Button
Power-On Source
Remote
LAN
Wake Up Timer
Wake Up Time
Wake Up Mode
Power Failure Recovery
PhoenixBIOS Setup Utility
[Enabled]
[Enabled]
[BIOS Controlled]
[Disabled]
[Enabled]
[Disabled]
[00:00:00]
[Daily]
[Previous State]
table: Items on the Power On/Off Submenu
Setting
-
Enabled (Unchangeable)
Enabled (Unchangeable)
BIOS Controlled
(Unchangeable)
• Disabled (Initial value)
• Enabled
• Disabled
• Enabled (Initial value)
Disabled (Unchangeable)
Sets when to turn the power on by timer.
Sets the interval to turn the power on by timer.
• Always On
• Always Off
• Previous State (Initial
value)
PRIMERGY RX200 S4 User's Guide
Item Specific Help
Description
Sets whether to turn the power off by the program
or by the OS.
Sets whether or not to allow the use of the power
switch for turning the power off, when the ACPI
function is disabled.
Sets the operation when turning the power on.
Sets whether or not the power is turned on when the
modem (connected to the serial port) receives a ring
signal.
Sets whether or not to enable the power to be turned
on via LAN.
Sets whether or not the power is turned on at a
certain time or after a certain time has passed.
Sets the state of the power when the system goes
down due to abnormal power, or after turning the
power back on by UPS.
Note:
When UPS is used, be sure to set to
"Always ON".
189