Power On/Off Submenu - Fujitsu PRIMERGY TX300 S4 User Manual

7.2.9 Power On/Off Submenu

This submenu appears when you select [Power On/Off] from the [Advanced] menu.
It is for power on/off settings.
Main Advanced
Power-off Source
Software:
Power Button:
Power-on Source
Remote:
LAN:
Wake Up Timer:
Wake Up Time:
Wake Up Mode:
Power Failure Recovery:
F1
Exit
Esc
Item
Power-off Source
Software
Power Button
Power-on Source
Remote
LAN
Wake Up Timer
Wake Up Time
Wake Up Mode
Wake Up Day
Power Failure Recovery
PhoenixBIOS Setup Utility
Security Server
Power On/Off
[Enabled]
[Enabled]
[Bios Controlled]
[Disabled]
[Enabled]
[Disabled]
[00:00:00]
[Daily]
[Previous State]
-/+ Change Values
Select Item
Select Menu Enter Select > Sub-Menu
table: Power On/Off submenu
Setting
–
Enabled (Unchangeable)
Enabled (Unchangeable)
BIOS Controlled
(Unchangeable)
• Disabled (Initial value)
• Enabled
• Disabled
• Enabled (Initial value)
Disabled (Unchangeable)
[00:00:00]
Daily (Unchangeable)
1 (Unchangeable)
• Always On
• Always Off
• Previous State (Initial
value)
PRIMERGY TX300 S4 User's Guide
Exit
Item Specific Help
F9 Setup Defaults
Description
Sets whether to turn the power off by using the
program or the OS.
Sets whether to allow the use of the power switch
for turning the power off when the ACPI function is
disabled.
Configures the power-on setting.
Sets whether or not the power is turned on when the
modem (connected to the serial port) receives a ring
signal.
Sets whether to enable the power to be turned on
via LAN.
Sets whether or not the power is turned on at a
certain time or after a certain time has passed.
Sets when to turn the power on by the timer.
Sets the interval to turn the power on by the timer.
Sets the interval to turn the power on by the timer.
Sets the power state of the server when the system
goes down due to abnormal power, or after turning
the power back on by UPS.
Note:
When using UPS, make sure to set to
"Always On".
205