Vlan - Fujitsu PRIMERGY RX200 S4 User Manual

When the teaming function normally starts running, event logs (ID = 6 to 8) are stored at boot of the
system. This is not a problem; no action is required.
Once a Team is setup, plural warning logs (ID = 11, 13, 22) and event logs (ID =15, etc.) may be stored
in the system log of the event viewer at boot of the system. This is not a problem; no action is required.
When enable [Link Standby] in the [Advanced Settings] of the LAN adapter, warning logs (ID = 11, 13,
22) and event logs (ID =15, etc.) may not be stored.
When not using the remote management function on the onboard LAN, event log (ID =42) may be
stored. When not using the remote management function, this is not a problem; no action is required.
When teaming starts operation properly, error log (ID =3) may be stored at system start. This is not a
problem; no action is required.

4.7.3 VLAN

Notes
The following are notes on using VLAN via Intel
However, when the content of help and this manual differ, follow the instructions in this manual.
• Up to four VLANs whose "NetBIOS over TCP/IP" is enabled in the whole system.
• Only ten or less VLANs can be set to a LAN port.
• When adding or deleting a VLAN, always use "Intel(R) PROSet". Do not disable or delete a VLAN
from the [Device Manager] or [Network Connections].
• On a VLAN, only use IP protocols.
When LLC and the LNDFC protocols are installed by the Fujitsu communication control service,
these protocols are bound (connected) unconditionally. Therefore, release the bind of VLAN and
these protocols in the system where these protocols and VLAN are installed at the same time.
Creating a VLAN
1
Click [Start] – [Administrative Tools] – [Computer Management] to start Intel
PROSet.
2
Click [Network adapters] under [Device Manager] and double-click a LAN card
to setup a VLAN.
3
Click the [VLANs] tab, and click [New...].
4
Specify [VLAN ID] and [VLAN Name]. Then click [OK].
The [VLAN ID] should be identical to the switch setting. 1 to 4094 can be specified.
Any name can be specified as the [VLAN Name].
PRIMERGY RX200 S4 User's Guide
®
PROSet. For details, refer to Intel
®
PROSet help.
®
119