Fujitsu PRIMERGY RX200 S4 User Manual page 209

Message
System battery is dead - Replace and run
SETUP
System CMOS checksum bad - Default
configuration used
System timer error
Real time clock error
Check date and time settings
Previous boot incomplete - Default
configuration used
CPU mismatch detected
Available CPUs do not support the same bus
frequency- system halted
table: List of POST error messages
The battery is abnormal. Check that the battery on the baseboard
is properly installed. If the message still appears, the baseboard
must be replaced. Contact an office listed in the "Contact
Information" of the "Start Guide".
The CMOS is abnormal. Correct the current settings with the
BIOS Setup Utility or configure the settings at the time of pur-
chase. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of the "Start Guide"
The system timer is abnormal. Power off the server and turn it
back on. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of the "Start Guide".
The Real Time Clock (RTC) is abnormal. Enter the correct time
on the "7.2.2 Main Menu" ( p.179) of the BIOS Setup Utility.
If the message still appears, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of the
"Start Guide".
The date and time that are set are abnormal. Check the date and
time setting on the "7.2.2 Main Menu" ( p.179) of the BIOS
Setup Utility. If the same error occurs frequently, the baseboard
must be replaced. Contact an office listed in the "Contact
Information" of the "Start Guide".
POST is not completed during previous booting. Be sure to
perform the following operation. Failure to do so may result in
the OS not starting or the server not operating correctly.
1. Turn on the server.
If the server is already turned on, restart it.
2. Press the [F2] key to start the BIOS Setup Utility. (Do not
press the [F1] key.)
3. Select [Save Changes & Exit] in "7.2.17 Exit Menu"
( p.199) and press the [Enter] key.
4. If message "Save configuration changes and exit now?"
appears, use the [←] [→] keys to move the cursor to
[Yes], and press the [Enter] key.
The BIOS Setup Utility closes and the server restarts.
After this, start the system as usual.
CPUs with varying frequencies are installed. Check the CPUs
before and after replacement in order to install the correct CPU.
If the message still appears after the correct CPU was installed,
BIOS requires to be updated. Update the BIOS using updating
tool supplied with new CPU. If the message still appears,
change the [Reset Configuration Data] setting to [Yes] on the
"7.2.5 Advanced Menu" ( p.183) of the BIOS Setup Utility.
Nevertheless, if the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of the "Start Guide".
CPUs with varying frequencies are installed. Install the correct
CPU. If the message still appears, the baseboard must be
replaced. Contact an office listed in the "Contact Information"
of "Start Guide".
PRIMERGY RX200 S4 User's Guide
Description
209