Power On/Off Submenu - Fujitsu PRIMERGY RX200 S2 User Manual

8.2.9 Power On/Off Submenu

Appears when [Power On/Off] is selected from the [Advanced] menu. Configures power On/Off
settings.
Advanced
Power On/Off
Power On Source
Remote:
Resume On Times:
Resume Time:
LAN:
Power Failure Recovery:[Previous State]
F1 Info Select Item
Esc Exit Select Menu
Item
Remote
Resume On Times
Resume Time
LAN
Power Failure Recovery
PhoenixBIOS Setup Utility
[Enabled]
[Off]
[00:00:00]
[Enabled]
-/+ Change Values
Enter Select Sub-Menu
table: Items on the Power On/Off Submenu
Setting
• Disabled
• Enabled (at the time of
purchase)
• Off (at the time of
purchase)
• On
-
• Disabled
• Enabled (at the time of
purchase)
• Always ON
• Always OFF
• Previous State
(at the time of purchase)
PRIMERGY RX200 S2 User's Guide
Item Specific Help
Setup Defaults
F9
F10 Save and Exit
Description
Sets whether or not the power can be turned on
when the modem (connected to the serial port)
receives a ring signal.
Sets whether or not to resume from suspend mode
at the specified time.
Specifies the time to resume in the 24-hour
"hours:minutes:seconds" format.
Sets whether or not to enable the power to be turned
on via LAN.
Sets the server power status after system down due
to power failure or after power recovery by the
UPS.
Note:
Set this item to [Always ON] when a UPS is
used.
8
221