Fujitsu PRIMERGY RX200 S4 User Manual page 26

Chapter 1 Overview
g Serial port (9-pin) (
Cables of peripheral equipment conforming to the RS-232C standard such as modems are
plugged in.
h Display connector (15-pin) (
A display cable is plugged in.
i LAN port 2 (
When LAN port 1 has already used, this port is used. The cables to be used and meanings of the
two LEDs are the same as the LAN port 1.
j Service LAN port (
By connecting a LAN cable, the remote management controller function can be used with Web
interface. When using Remote Management Controller, refer to"Appendix D Remote
Management Controller" ( P. 257).
k Power supply unit slot 2 (optional)
An optional power supply unit can be installed and up to two units can be installed in this server.
Adding a power supply unit enables the redundant power supply function.
l Power supply unit LED
This LED shows PSU status. The meaning of the LED is shown below.
LED status
Green
Blinks in green
Amber
Blinks in amber
m Power supply unit slot 1 (installed standardly)
One PSU is installed by default. Up to two units can be installed.
n Inlet
The AC power cables are plugged in.
26
)
)
)
)
table: PSU status
Power supply status
Normal status
AC power is connected, but the power does not supplied.
AC power is connected or abnormality is detected in the PSU.
Abnormality is detected in the PSU.