Using The Fiber Channel Controller (Pg-Fc202); Turning The Power On Via A Lan; Changing The System Drive Size (Only For Windows Server 2008) - Fujitsu PRIMERGY RX200 S4 User Manual

Chapter 4 Operations after OS Installation

4.5.4 Using the Fiber Channel Controller (PG-FC202)

To use the Fiber Channel Controller (PG-FC202), the driver needs to be updated after installing the OS.
You can use the driver supplied with the Fiber Channel Controller or download it from the Fujitsu
PRIMERGY website (http://primergy.fujitsu.com).

4.5.5 Turning the Power On via a LAN

You can turn the power on the server from a client (via a LAN) by utilizing the Wakeup on LAN (WOL)
function.
Be sure to install ServerView to control the power supply via a LAN.
When the power cable is disconnected from the server or the server is powered off due to power
interruption, restart the server. Unless otherwise, the WOL function will be disabled.
Only the onboard LAN is available to correspond to the WOL function for this server. To control power
supply via a LAN, connect the onboard LAN and set the onboard LAN adapter bind to "1" for sure.
BIOS Setup Utility setting
When perform power management via a LAN, set [Enabled] in the [LAN] item of the "7.2.9 Power On/
Off Submenu" ( p.189) in the BIOS Setup Utility. The [Enabled] in the [LAN] has been set as the initial
setting.
4.5.6 Changing the system drive size (only for Windows
Server 2008)
For Windows Server 2008, the partition size can be extended or reduced after installation has completed.
Extending the partition size of a system drive
To extend the partition size of a system drive, perform the following procedure.
1
Log on to the server with administrator privileges.
2
Click [Start] – [All Programs] – [Administrative Tools] – [Server Manager].
Server Manager starts.
3
Double-click [Storage] – [Disk Management].
The [Disk Management] window appears.
94