G
G
Loading Paper
Place paper stock of the
desired size against the
bottom-right corner of the
tray.
Adjust the guides
2
according to the size of the
paper.
Remove the paper from
the tray and use a
screwdriver to fasten the
G If the guide is not fastened properly,
screws as shown in the
paper jam may occur.
diagram.
Check that the guides are locked
at the holes with the screws
tightened. Then re-load the paper.
Paste the new paper size
label on the front of the
tray.
Push the tray in slowly until
it stops.
Refer to the procedures described
on the following page to change
the paper size.
29
2-4 Changing the Paper Tray Size