Xerox Document Centre 706 Series User Manual page 102

G G
Basic Features
G Chapter 3 Loading Documents for
information on how to load
documents.
G For documents of mixed sizes, use
the DADF.
G 5-10 Selecting the Original
Orientation (Original Orientation) for
details.
4
G Select Cancel to cancel the settings.
G Some features cannot be selected
together with this feature. See
Appendix B Possible Combinations
of Features for details.
G To stop the copy job, press Stop on
the control panel or touch Stop
displayed on the screen. See 4-11
Stopping a Copy Job for details.
G If the Punching feature is off in Step
3, copies will be output to finisher
tray 1.
G Do not remove any paper from
finisher tray 2 while copies are being
output.
G Copying stops when finisher tray 2
becomes full with 100 sets or 1500
sheets (750 sheets for sizes greater
than A4). Remove the copies from
finisher tray 2, then press Start to
resume copying.
78 4-9 Punching Holes (Punching)
Load the original in the orientation of Head to Top, or Head to
Left.
Select the corresponding document orientation of the original
loaded, and select Save.
Select Head to Top or Head to Left.
Confirm the settings at the lower left side of the screen and
select Save.
Select other features if necessary.
Enter the required number of sets by using the keypad and
press Start.
The copies are punched and delivered to finisher tray 2.
You can remove the copies from finisher tray 2 after all the
copies are delivered and the machine stops.